Brief Instructions For Steroid Injectables HomeBrew – Step by Step
In Muscle Building, guys are always spend big money on steroids injectables or tablets per month. And sometimes even get shits from those suppliers. That makes Muscle Building guys lose much more time and money but get nothing. We offer steroid powders with purity 99% min. With us, you get what you pay for. If any interests, please don’t hesitate to email me.
However, home-brewing steroids has basically become more and more popular since China started producing raw grade hormone powders, so it becomes relatively easy to acquire those and over here.
Alright guys, making injectable steroids isn’t hard, it’s not easy either, just takes some reading, some patience and a few things you can buy easily and legally online……the only thing “illegal” you will need is of course the experimental steroid powders.
Powders just like cocaine can and most likely are “cut” and impure if not gotten from the best of sources, so a good powder guy is the first thing you will need…..David, my name, would try my best to help you guys to get nice powders and help you guys to acquire the equipment you may need for converting.
Well, here is a step by step for 100 ML of testosterone enanthate conversion @ 250 mg/ml for example:
This is a way more than 25 grams but i’ll show how to measure out. Sounds simple but its kinda tricky.
All right let’s begin,
1 First you weigh out your powder.
Now you have to do this very carefully: get your small piece of paper and place it on the scale then press tare to set it to zero so it doesn’t weigh the paper. Then slowly add your powder. Now here is the tricky part the powder weighs so little that the scale needs to be reset every time you add some. All you have to do is add some then press on the scale with your finger and let the number fall back down. Once you get 25 grams your good to go.
2 Then dump it into your beaker.
Add 2ml of Benzyl Alcohol (BA) (USP)
Then add 18ml of Benzyl Benzoate BB) (USP)
3 Next step is sort of optional but its makes things easier. Get a pot with a bout an inch of water in it and place it on the stove and set the eye to 3.
Put the beaker in it.
Watch the powder dissolve and the mixture get pretty close to clear.
4 Next add you grape seed oil and let it all warm up for a bit to make filtering a little bit faster. This is a picture right after I added the oil. In put it back on the eye for a minute and mixed it.
5 Then draw 10 ML of the conversions and get your syringe filter and push filtered conversions into the sterile vials:
or you can choose vacuum pump to filter:
(Pour the oil in and attach the vacuum pump and set it between 300-400. THIS IS THE SAFETY ZONE.)
Done the whole filtering process takes about 30 minutes but all you have to do is pump and walk away.
6 Next you measure out 10ml in each vial
7 Then you put the rubber stoppers and flip off tops on them and crimp them.
And now your done. You have now made 100 ml of test E and put in 10 x 10 ml vials. If you have questions pm me.